back



Accessories


Rako’s accessories compliment home security, linking the system to security alarms that bring lights on in the event of activation. The TCM time-clock can turn lights on automatically at dusk, run a sequence or replay normal occupancy during holidays For ultimate flexibility, Rako has a range of modular accessories including hand held remotes, single and bi-directional RS232 interfaces, infrared to RF converters, boosters, DMX512 drivers, partition modules, volt-free interfaces and astro time clock with advanced macro programming features.

Products

RX LINK

RX-LINK
The RX LINK module provides RF reception for the RAK-4 range of dimmer racks

RF Hand held remote control

RAH07
The RAH07 wireless hand held controller with 4 scenes, off and master raise and lower buttons

WRA-232 Bridge

WRA-232
A network interface for use with Rako wired, wireless or combined systems.  The WRA-232 Bridge acts as a bi-directional interface with external control devices via either serial RS232 or Ethernet.

USB RF Gateway for Rasoft

RAUSB
Designed to operate with the Rako RASOFT PC programming software. The unit provides a wireless link from a PC running RASOFT to RAKOM enabled receiver devices such as the RDL range of dimmers.  ...

WRB100

Rako Signal Repeater
The WRB100 is a flexible signal repeater for use with either wireless only or combined wired and wireless Rako systems. Typically located centrally between push button wall plates and dimmer receivers.

Presence sensor with integral daylight sensor, mains powered

RAPIR
The RAPIR is a ceiling mounted 360o PIR motion sensor with Rakom RF capabilities

Intelligent partition control unit

RAIPC
The Rako RAIPC is an intelligent partition control unit designed for use in rooms that are divisible into smaller rooms by demountable partitions.

RA Bridge

RA Bridge
Bridge for interfacing with wireless receivers from ethernet iPhone link

RTC Bridge

RTC Bridge
Interface with wireless dimmers with Ethernet, iPhone, or Android link.  Fitted with TCM time clock module allowing event timed commands, holiday simulation mode, macro & button mapping.  Supplied with Rako software allowing programming & configuration of the wireless system.

WA Bridge

WA Bridge
Interface between wired and wireless networks with ethernet link (requires wireless router to use for programming)

WTC Bridge

WTC Bridge
Interface with wired or wireless dimmers with Ethernet, iPhone, or Android link.  Fitted with TCM time clock module allowing event timed commands, holiday simulation mode, macro & button mapping.  Supplied with Rako software allowing programming & configuration of the system

TCM (TIMECLOCK MODULE)

TCM
A time-clock and advanced programming module that can be connected to a RA-Bridge or a WA-Bridge converting them to RTC and WTC Bridges respectively, allowing timed events, holiday simulation and macro functions to be programmed.

Infrared to RAKOM radio interface unit.

RAVIR
The RAVIR is an infrared to RF interface to convert infrared control signals to Rakom RF

USB Wireless and NFC Interface Module

RAMPI
The Rako RAMPI is a programming device for either wireless systems (replacing the obsolete RAUSB) via RF or Rako NFC (Near Field Communication) devices such as the RNC wallplates or RCI-4L and RCI-7M interfaces. The RAMPI incorporates RF receive and...

RSRDMX

RSRDMX
Wireless 15 channel DMX controller for DMX controlled LED and other DMX light fixtures.

RSR-DALI

RSR-DALI
The RSR-DALI is a wireless control module giving control of up to 15 addressable channels of DALI controllable fittings in a single Rako Room.

RMR-VF

RMR-VF
The RMR-VF is an interface unit to convert volt-free contact signals into Rako wireless RAKOM messages

RAMVR

RAMVR
The RAMVR is a wireless interface module for third party presence sensors.